How to detune a new snowboard

This story originally appeared in TRANSWORLD SNOWBOARDING. Words by TRANSWORLD SNOWBOARDING.

A proper detuning is in order any time you unsheathe a new board. Sure, you can get by without it, but be prepared for unexpected edge hooks in the worst possible places, like, say, icy cat tracks first thing in the morning or cold steel rails on your last lap through the park. Count on it. Or follow these five steps to detuning your new board and up your odds of staying on your feet first chair to last.

What you need

Everything you need to detune a snowboard. Photo: Nick Hamilton/TRANSWORLD SNOWBOARDING

– Medium-coarse file. It can be found at any hardware store.
– Gummy stone. Great for removing minor burrs; a good thing to have in your pocket at all times.
– Diamond stone. Use like the gummy to polish your edge.

1. Remove major burrs

Remove any burrs. Photo: Nick Hamilton/TRANSWORLD SNOWBOARDING
This is essentially the first once-over treatment with the file to buff out any of the gnarly snags in your edge. Find the trouble spots and smooth them out.

2. Detune tip and tail

Detune the tail and the tip. Photo: Nick Hamilton/TRANSWORLD SNOWBOARDING
Find the widest part of your board at the nose and tail; that’s called the contact point. It’s the section of edge that’s most likely to catch on hardpack. Then start an inch back from that point and use the file to round out the edge toward your nose.

3. Light detune of the entire edge

Lightly detune the entire edge. Photo: Nick Hamilton/TRANSWORLD SNOWBOARDING
Visually divide your edges into three sections. Place the file on your edge at about a 45-degree angle and make one or two passes over each of the sections. The idea is to just take a little bit of the edge off. This probably isn’t necessary for pipe jocks, East Coast riders or any of you closet Euro carvers out there, because all of you will want to keep that edge razor sharp.

4. Remove all edge shards with a cloth

Remove all edge shards with a cloth. Photo: Nick Hamilton/TRANSWORLD SNOWBOARDING
Clean up all that shredded edge so as to keep those micro shards off your board and out of the base.

5. Polish the edge with a gummy and/or diamond stone

Polish. Photo: Nick Hamilton/TRANSWORLD SNOWBOARDING
Although it might seem like your edge is smooth, there are really a lot of little micro burrs that need buffing out, so take that gummy or diamond stone to the edge and finish it off right.


How To Wax A Snowboard

Stale Sandbech, Alek Oestreng, and Len Jorgensen at Fonna Glacier

For access to exclusive gear videos, celebrity interviews, and more, subscribe on YouTube!